Remove The Leveling Dryer Legs; Install Spacers To Dryer Bottom; Installing Appropriate Brackets - Haier GE GFW510SCN0 Technical Service Manual

Remove The Leveling Dryer Legs

1. Carefully lay the dryer on its back or side.
Use the packing material so not to scratch the
finish on the dryer.
2. Use an open-end wrench or pliers to remove
all four dryer leveling legs. NOTE: Retain the
leveling legs for future use.

Install Spacers to Dryer Bottom

1. Locate a spacer on the bottom side with its
holes over the leveling leg holes. Attach
spacer using two screws. Attach the second
spacer on the other bottom side using two
screws. NOTE: The arrows on the spacers
should point to the outside.
Make sure the arrows on the
spacers point to the outside.
using two screws
Front
Make sure the arrows on the
spacers point to the outside.

Installing Appropriate Brackets

Washer
Dryer Depth
Depth
32-inch
34-inch
Select the appropriate brackets for your model
sizes. Using the outside holes in the bracket,
attach it to the top left corner of the washer back
using four screws. Repeat on the top right corner
of the washer back.
– 24 –
Attach spacer
Attach spacer
using two screws
Bracket
Number
32-inch 32-inch
32-inch 34-inch
Back