Haier GE GFW510SCN0 Technical Service Manual page 36

Step 7: Remove Lock Assembly And Install On
The Other Side Of Washer
• Remove the two screws from the lock cover
and remove it from the washer face.
• Insert the provided lock bar into the lock
mechanism in the washer face. Remove the
lock assembly by removing its two screws,
using the lock bar to lift it up to unhook,
tilting and pulling it out of the washer face.
Disconnect its pin connector by unsnapping
its locks.
Pin Connector
Lock
Cover
Hook
Window
Hook
Insert Lock Bar
Remove
Assembly
• Do NOT rotate lock assembly. Move it to
the opposite side of the washer and connect
the pin connector making sure it is fully
snap locked together. Tilt and insert the
lock assembly into the washer face, lift it up
and latch its hook into its window. Replace
its screws. Remove the lock bar from the
assembly and retain for future use.
Hook
Replace
Assembly
Remove Lock Bar
Pin Connector
• Install the lock cover over the lock assembly,
making sure the locating post fits into the
locating hole and that the lock switch operates
freely. Replace its screws.
Lock Cover
Lock Switch
Locating Post
Locating Hole
– 36 –
Hook
Window