On a VLAN interface can only one link-local address be set. After IPv6 is enabled through the configuration of the link-local address, IPv6 only takes effect on the local link. To set a global IPv6 address in VLAN interface configuration mode, run the following commands. www.fs.com...
Page 4
When IPv6 is enabled through the configuration of a global address, all interconnected IPv6 device can be handled by IPv6. If a link-local address has not been set before the configuration of the global address, the system will set a link-local address automatically. www.fs.com...
Page 5
Users can use ACL to control the reception and transmission of packets on a VLAN interface. If you introduce ACL on a VLAN interface in global configuration mode and designate the filtration's direction, the IPv6 packets will be filtered on this VLAN interface. To filter the IPv6 packets, run the following command in interface configuration mode. www.fs.com...
Page 6
POE+ SERIES SWITCHES IPV6 CONFIGURATION GUIDE Command Purpose Filters the IPv6 packets in the reception or transmission direction (in: ipv6 access-group WORD {in | out} receive; out: transmit) on a VLAN interface. www.fs.com...
Need help?
Do you have a question about the S3150-8T2FP and is the answer not in the manual?
Questions and answers