Advertisement
CONFIGURATION GUIDE
COMPONENTS
CONFIGURATION
Visit rubiq.edventures.com, click on Configuration in the top right corner of the page and begin the
RubiQ configuration process.
Step 1. Bind the RX to the Radio Controller & Set the Failsafe.
Step 2. Verify RX Channels & Failsafe.
Step 3. Verify AUX Channels.
Step 4. Verify Switches.
Step 5. Verify LEDs.
Step 6. Verify Motor Rotation.
Step 7. Calibrate ESCs.
Step 8. Calibrate Accelerometer.
Step 9. Set Magnetic Declination.
At the end of a successful configuration, the RubiQ Configurator's Pre-arming Checks, found in the Setup
tab, will show all categories with a green checkmark except for "Compass Calibrated" and "Navigation is
safe." This is for two reasons:
•
The compass needs to be calibrated outside as part of the pre-flight check.
•
RubiQ requires a GPS lock in order to arm the motors and fly. Navigation is safe indicates the
GPS lock status, which defaults to red until a lock has been achieved. See Step 7 of the Pre-Flight
Checklist for further information about GPS lock.
Follow the Pre-Flight Checklist on the following page to fully prepare RubiQ for liftoff.
For support, visit:
© 2021 PCS Edventures, Inc.
rubiq.edventures.com/support
RubiQ
FLIGHT MANUAL
19
Advertisement
