Advertisement
Screen Display
Speed display
Battery display
Gear display
Item name
Item display
G ear Mode
Click
and
button to adjust
Gear Mode 1Gear(8MPH),2Gear(16MPH),3Gear(23MPH)
Item Name
ODO:Total mileage display // DIS:Single time range display // VOL:Voltage(Press power button to switch item name)
Throttle:
Press throttle to accelerate
Battery Display
Each battery bar represents 20% powe r, when the battery is below 20%,
the battery needs to be charged
Upsfift
Upsfift
Power button
Power button
Downshift
Downshift
Throttle
4
4. Assembly and Set up
Before you begin: Remove contents from box. Remove the separators that protect the components from damage during shipping.
Inspect the contents of the box for scratches in the paint, dents, or kinked cables that may have occurred during shipping. Because
the electric scooter was partially assembled and packed at the factory, there should not be any problems, even if the box has a few
scars or dents.
MAKE SURE POWER SWITCH IS TURNED "OFF" BEFORE CONDUCTING ANY ASSEMBLY OR MAINTENANCE PROCEDURES.
Hiboy recommends assembly by an adult with experience in bicycle mechanics.
Unfold the scooter(Open the folding lock)
Attaching the Handlebars
Required Tools: 5 mm Allen Wrench (included)
1. Loosen the screw on Top of T-tube
2. Put the handle bar on(the thread part should be in the middle)
3. Tighten the screw
Note: The Angle of handle can be adjusted according to personal habit during installation.
Tighten the Rod of Rear Fender
Required Tools: 3 mm Allen Wrench (included)
1. Loosen the screw on rear wheel (See image)
2. Align the rod with the hole
3. Tighten the screw
Attaching the headlight
Required Tools: 2 mm Allen Wrench (included)
1. Loosen the screw on headlight
2. Align the headlight with the hole on the top of front fork
3. Tighten the Screw
Need Help? Please search "Hiboy us" on Youtube website to find our Channel. You can watch the Installation video
of VE1 PRO. Or contact Hiboy after-sale team by email: support @hiboy.com.
5
Advertisement
