Table Of Contents; Compatible Rqt Quick Talk™ Models; Rqa-1B/4B Fcc Part 15 Statement; Rqa-1B/4B Fcc Part 15 Instructions - Ritron RQA-1B Owner's Manual

Table of Contents ......................................................................

Compatible RQT Quick Talk™ Models ........................................................... 2
RQA-1B/4B FCC Part 15 Statement ............................................................... 2
RQA-1B/4B FCC Part 15 Instructions ............................................................. 2
General Information ........................................................................................ 3
Operating the RQA-1B .................................................................................... 4
RQA-1B Battery Replacement ........................................................................ 4
Setting the RQA-1B ........................................................................................ 5
Set the Address ........................................................................................ 5
Set the CONFIG Switches for Keyfob Code Operation ............................ 6
Set the LOCATION Switches for Keyfob Code Operation ....................... 6
Basic Quick Talk™ Radio Operation .............................................................. 7
Quick Talk™ Radio Battery Life ...................................................................... 7
Setting up an RQT Quick Talk™ RCVR Keyfob System ................................ 7
RQT Quick Talk™ Programming for RCVR Models ................................. 7
Programmable RQT Radio Attributes ....................................................... 8
Ritron, Inc. Limited Warranty ........................................................................... 9
Compatible RQT Quick Talk
The RQA-1B Wireless Call Button is designed to operate with the following
Ritron RQT Quick Talk™ models. These Quick Talk™ transmitters have an
RQT-433-RCVR receiver installed.
Keyfob Operation:
RQT-151-RCVR RQT-151M-RCVR
RQT-152M-RCVR RQT-451-RCVR
Notes:
1. This Owner's Manual is for Ritron model RQA-1B with firmware revision
35.02 or greater. A label is affixed to the RQA-1B printed circuit board
that indicates the firmware revision installed.
2. The RQT-xxx-RCVR Quick Talk™ must have firmware revision 32.11 or
greater. A label is affixed to the RQT-XXX-RCVR printed circuit board
that indicates the firmware revision installed.
_________________________________________________________________________________________________________________________________
Models ....................................
™
RQT-152-RCVR
RQT-452-RCVR
For assistance, call RITRON at 800-872-1872, or go to

RQA-1B/4B FCC Part 15 Statement ..........................................

This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. You can test to see if this
equipment does cause harmful interference to radio or television reception by turning the
equipment off and on.
Caution: Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.

RQA-1B/4B FCC Part 15 Instructions ......................................

This device complies with Part 15 of the FCC Rules.
Operation of this device is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
•
Consult the dealer or an experienced radio/TV technician for help.
This equipment has been certified to comply with the limits for a Class B computing device,
pursuant to FCC Rules. In order to maintain compliance with FCC regulations, shielded cables
must be used with this equipment. Operation with non-approved equipment or unshielded cables
is likely to result in interference to radio and TV reception. The user is cautioned that changes
and modifications made to the equipment without the approval of manufacturer could void the
user's authority to operate this equipment.
www.ritron.com 2