Table of Contents
Advertisement
Care and maintenance instructions
Control panel
Keep the control panel clean. If necessary, wipe it with a dry or slightly damp cloth. Never use
cleaning products
Run Self-cleaning
Dishwasher tub
The dishwasher tub is made of stainless steel and is kept clean through normal use (when used
regularly).
If you have hard water, limescale deposits may build up in the dishwasher. If this happens, run the
Self-cleaning program with two tablespoons of citric acid in the dishwasher's manual detergent
compartment (with no dishes in the machine). Special dishwasher cleaners are also available in
stores.
Never use anti-freeze, Draino
Remove blockages
Unblocking the drain pump
If the dishwasher still contains water after the program has finished, something may be blocking the
drain pump, which results in the error message Water outlet fault or BLDC drain pump fault.
1. Turn off the machine using
2. Remove the coarse filter and the fine filter.
3. Scoop out the water from the dishwasher tub.
4. In order to inspect the drain pump, remove the yellow drain pump stop on the right in the bottom
drain. (Use a pair of pliers if necessary.)
5. Turn the pump wheel located behind the drain pump stop by hand. Carefully remove any sharp
items, such as glass.
6. Reinstall the drain pump stop along with the fine and coarse filters.
7. Plug the machine in again.
NOTE!
Do not forget to reinstall the drain pump stop.
40
they may scratch the surface.
®
®
, CLR
, or other chemical cleaners.
and remove the plug from the power outlet.
Drain pump stop
Advertisement
Table of Contents
