Canon PIXMA MG6120 Service Manual page 10

Multiple ink tanks [1487]
of the same color
installed.
Ink tank in a [1680]
wrong position.
Warning: The ink [1700]
absorber becomes
almost full.
The connected [2001]
digital camera or
digital video
camera does not
support Camera
Direct Printing.
Automatic two- [1310]
sided printing
cannot be
performed.
Failed in [2500]
automatic print
head alignment.
U071 More than one ink
tank of the following
color is installed.
U072 Some ink tanks are
not installed in place.
--- The ink absorber is
almost full. Press
[OK] to continue
printing. Contact the
service center for
replacement.
--- Incompatible device
detected. Remove the
device.
--- This paper is not
compatible with two-
sided printing.
Remove the paper
and press [OK].
--- Auto head align has
failed. Press [OK]
and repeat operation.
<See manual>
6 / 66
Replace the wrong ink tank(s)
with the correct one(s).
Install the ink tank(s) in the
correct position.
Replace the ink absorber, and
reset its counter. [See 3-3,
Adjustment and Settings in
Service Mode.]
Pressing the OK button will exit
the error, and enable printing
without replacing the ink
absorber. However, when the ink
absorber becomes full, no further
printing can be performed unless
the applicable ink absorber is
replaced.
Remove the cable between the
camera and the machine.
The paper length is not supported
for two-sided printing.
Press the OK button to eject the
paper being used at error
occurrence.
Data which was to be printed on
the back side of paper at error
occurrence is skipped (not
printed).
Press the OK button to clear the
error, then perform the automatic
print head alignment again. (Use
Matte Photo Paper MP-101.)
- Ink tank
- Ink tank
- Absorber
kit
- Duplex
paper
feed
roller
unit
- PE sensor
board
ass'y
- Carriage
unit
- Print
head