Cleaning The Hood Body; Cleaning The Metal Filter; Activated Charcoal Filter; Problem Solving - Teka DVI 88-G1 Series User Manual

Cleaning and maintenance
During cleaning and maintenance work,
make sure the safety instructions are
complied with.

Cleaning the hood body

•If your kitchen hood is made of stainless steel,
use proprietary cleaners mentioned in the
product instructions.
•If your kitchen hood is painted, use lukewarm
water and a neutral soap.
•Never use metallic scourers, nor abrasive or
corrosive products.
•Dry the kitchen hood using a cloth that does not
produce fibres.
•Do not use vapour cleaners
Proceed with the following checks before calling the Technical Service:
Problem
The kitchen hood does not
work.
The kitchen hood does
not extract sufficiently or
vibrates.
•To remove the filters from their fittings, press
•The metal filters can be cleaned by soaking
•Cleaning in a dishwasher may damage the
•Once clean, leave them to dry off and then fit
•Remove the grease collector as described at
• To install the active carbon filter follow the
instructions supplied with it.
• The manufacturer reserves the right to
make any corrections it deems necessary
to its devices without damaging its essential
characteristics.
• It is possible that with the installation of
carbon filters, a reduction in the extraction
flow can be observed in the hood.

Problem solving

Possible cause
The mains cable is not
connected to the network.
There is no current in the
network.
Filters are saturated with fat.
Obstruction in the air outlet.

Cleaning the metal filter

lightly on the locks and then pull them off.
them in hot water with neutral detergent until the
fat dissolves and then rinsing them under the tap
or using special anti-grease products. They can
also be washed in a dishwasher. In this case, it
is advisable to stack them vertically to avoid food
residues to stick to them.
metallic surface (blackening it), although this will
not affect its fat retention capacity.
them onto the kitchen hood.
the end of this manual. Clean it in the same
way that filter.

Activated charcoal filter

Connect the mains cable to the
Provide current to the network.
Change or clean the active
charcoal and/or metal filters.
Remove the obstruction.
Solution
network.