Table of Contents
Advertisement
LPC2148 DEVELOPMENT BOARD
2.4 Using uVision Debugger in simulator mode
To use Debugger in simulator mode first we need to setup the debugger so as to use
simulator.
1. Right click Target 1 and select the highlighted option as shown in the figure below.
2. In the debug tab make sure that the highlighted settings are done. Click OK to
continue.
NEX Robotics Pvt. Ltd.
37
www.nex-robotics.com
Advertisement
Table of Contents
Need help?
Do you have a question about the LPC2148 Pro and is the answer not in the manual?
Questions and answers