VERVIEW 2.1. Sensor Overview The wireless sensors designed and manufactured by Radio Bridge provide full sensor to cloud solutions for Internet of Things (IoT) applications. The wireless ambient light sensor uses a light sensor to detect lighting levels in a room. When the lighting level increases beyond or drops below user defined thresholds, an alert is sent over the wireless network.
Table 2 Document Conventions Font / Icon Meaning Important notes Warnings and cautions 2.4. Part Numbers Table 3 Part Numbers Part Number Rating Wireless Region RBS101-AL-RCZ1 Indoor Sigfox Europe, Middle East, Africa RBS101-AL-RCZ2 Indoor Sigfox North America, Brazil RBS101-AL-RCZ4 Indoor Sigfox...
For an accurate estimate of battery life, please refer to the “Sensor Battery Estimator.xlsx” spreadsheet on the Radio Bridge website. This spreadsheet combines usage information such as average number of messages per day and estimates the battery life for a particular sensor.
IGHT ENSOR reduction in voltage over time. Radio Bridge sensors are shipped with lithium batteries, and these are recommended when the battery needs to be eventually replaced. Temperature also plays a role in battery life. The battery life estimates in the online spreadsheet assume room temperature, but temperatures close to the maximum and minimum ratings will have a negative impact on battery life.
6.1. Common Messages There are common messages across all wireless sensors that are defined in the document “Common Sensor Messages” which is available on the Radio Bridge website. Refer to the document “Common Sensor Messages” for definitions of all common messages. Common messages are not defined in this document.
IRELESS MBIENT IGHT ENSOR 0x01 Ambient light has risen above upper threshold 0x02 Ambient light has fallen below lower threshold 0x03 Report on change increase 0x04 Report on change decrease The current ambient light field in the ambient light event uplink message is the current measurement on a scale of 0-255.
IRELESS MBIENT IGHT ENSOR Periodic reporting minute or hour intervals. Default is 0 (disabled) Restoral margin (bits 3:0 only). Lower ambient light threshold. Upper ambient light threshold. The upper and lower ambient light thresholds are unsigned values and should fall on the scale 0-255.
15 minutes, byte 1 would be set to 0x8f. Note that prior to firmware version 1.3, only hourly reporting is available. The firmware version can be found in the reset message and is logged on the Radio Bridge console.
(2) this device must accept any interference received, including interference that may cause undesired operation. Per FCC 15.21, Changes or modifications not expressly approved by Radio Bridge could void authority to operate the devices. Sigfox RBS101 sensors FCC ID: 2APNUSFM10R2...
UPPORT Radio Bridge offers free technical support at: https://support.radiobridge.com Radio Bridge also offers technical support plans and service packages to help our customers get the most out of their Radio Bridge products. ISCLAIMERS Information in this document is subject to change without notice and does not represent a commitment on the part of Radio Bridge.