EN
Installation
Using provided template, at the intended location screw the self-threading screws leaving gap of approximately
1 mm from the plane.
2. Connect the cable to the controller
2.1- standard cable connection
PIN1 - +24V
1
4
PIN2 - B+
PIN3 - A-
PIN4 - COM
PIN1 - +24V
1 2 3 4
PIN2 - B+
PIN3 - A-
PIN4 - COM
2.2 - spec connection (see "8 pin connection").
3. Attach the special controller by positioning it rotated to the left at the angle of 25°.
4-5. Turn the controller to the right until the controller contacts the plane. Remove the used template.
IT IS FORBIDDEN to leave the remaining remote controller's
cable in the AHU's control box!
34
www.salda.lt