BEGA 84 235 Installation And Technical Information

BEGA
Installation and Technical Information
Tools Required:
• Adjustable wrench
• 6mm hex head screwdriver
Overview:
LED Watts: 95.6W
System Watts: 107.0W
Controllability: 0-10V dimmable
Weight: 12.1 lbs.
Protection Class: IP65
Notice to Installer:
1. See page 2 for specific product safety warnings.
2. Provided with 1/2" IPS threaded nipple for direct attachment to pole couplers, cast
wiring boxes, or other mounting accessories either by BEGA or others.
3. Floodlight is provided with 4' of 18/5 SJTOW cable.
Installation: Luminaire
1. Route cable to splice location.
2. Make supply wiring and luminaire wiring connections:
MAIN VOLTAGE SUPPLY WIRE TO BLACK LUMINAIRE WIRE
NEUTRAL (COMMON) SUPPLY WIRE TO WHITE LUMINAIRE WIRE
GREEN GROUND WIRE TO GREEN LUMINAIRE WIRE
Dimming (if applicable):
DIMMING CONTROL (+) TO POSITIVE LUMINAIRE DIM CONTROL WIRE
DIMMING CONTROL (-) TO NEGATIVE LUMINAIRE DIM CONTROL WIRE
3. Insert male threaded part from floodlight into coupler on pole, wiring box, or other
mounting accessory (Figure 1).
4. Tighten hexagon nut on top of connector assembly using an adjustable wrench to
secure the floodlight into place.
5. To adjust head angle, use 6mm hex head screwdriver to loosen screw at aiming
joint. Aim luminaire head as needed and tighten screw to secure into place. (Figure
2).
Accessories
Please refer to the appropriate accessory installation
sheet for further instruction when applicable.
Surface mount conduit wiring box
Direct burial wiring box
Earth spike
Pole cap - 3" O.D. pole tenon
Wood screw
BEGA 1000 Bega Way, Carpinteria, CA 93013 (805)684-0533 © copyright BEGA 2022
Due to the dynamic nature of lighting products and the associated technologies, luminaire data on this sheet is subject to change at the discretion of BEGA North America. For the most current technical data, please refer to bega-us.com
19 593 Tube clamp
19 594 Screw clamp
70 204 Pole mount arm
70 249 Mounting block
70 252 Pole coupler
High performance floodlight - wide beam
Dimensions
A: 9-3/4
B: 17-3/4
C: 2-1/8
Figure 1:
Figure 2:
Aiming Joint
Maintenance:
Clean regularly with solvent-free cleaner
removing dirt and debris. Do not use high
pressure cleaners.
70 280
70 283
70 379
79 511
71 042
Replacement Parts
See label inside of fixture for LED replacement
part number.
Consult factory for all other replacement
components.
84 235
Updated: 08/22/22
84 235 1 of 2