Advertisement
Installation and Operation
Your Phantom Gooseneck Microphone requires industry
standard 48 volt phantom power to operate properly.
The phantom power supplied from your mixer is used for
both the microphone element and for the built-in signal
processing that is included in your SGM microphone.
45-SW
40-SW
Installing your SGM Mic
SGM mics with integrated bases are terminated with a
standard male XLR connector. Install these by simply
plugging the mic into your microphone cable.
Verify Operation
If your SGM mic is plugged in properly and phantom
power is turned on in your mixer you will see the SGM's
LED turn green. Controls are located on the bottom
of the base.
Controls and Indicators
Two-Color LED
Controls on bottom of base
IR Gate: Time control button
Use Phantom tool
IR Gate: Range control button
Use Phantom tool
AGC/Plosive control pot
Use Phantom tool
Switch Function Control
Three position slider
See the chart on page 10 for
a summary of all control and
indicator functions.
8
45-NS
40-NS
Button (SW models only)
PHANTOM
MIC RIDER PRO
IR TIME
IR RANGE
AGC
ON/OFF SWITCH
ON TOGGLE PRESS
SABINE
45-SW
Operating your SGM Mic
After you plug in the SGM mic and the green LED
comes on, you are ready to adjust the mic's level on
your mixer. The mic capsule is designed to work best
when the user is between 3 and 6 inches away from
the mic. Set your levels for a normal speaking voice at
those distances.
Use the included Phantom tool to adjust the settings
on your SGM mic.
Infrared Gate
The heat-sensing IR sensor is integrated into the housing
of the mic capsule. This sensor reacts to changes in
body heat, so when a person gets in front of the mic it
will turn on the mic. When a person walks away from
the mic, the sensor will turn the mic off. Do not block
the sensor or you will defeat the sensing action.
Controls: Time and Range, or Disable the Gate
TIME: Set the time it takes to turn off the mic after
someone walks away from the mic.
Settings: 5, 10, or 15 seconds. Default is 10 seconds.
Control: A momentary push of the IR Gate Time
control button reveals the current setting. Press
again to cycle to the next setting. Repeat to cycle
back to the beginning.
Indicator: The two-color LED will flash red once to
indicate a 5 second IR Gate time, two times for a 10
second IR Gate time, and 3 times to indicate a 15
second time.
TM
RANGE: Set the operating distance at which the
sensor either turns on or turns off the mic.
Settings: 3, 6, or 9 feet, or disabled. Default is 6 feet.
Control: A momentary push of the IR Gate Range
control button reveals the current setting. Press
again to cycle to the next setting. Repeat to cycle
back to the beginning.
Indicator: The two-color LED will flash red once to
indicate a 3 foot (one meter) IR Gate distance, two
times for a 6 foot (two meter) IR Gate distance, 3
times to indicate a 9 foot (three meter) distance, and
4 times to indicate the IR Gate is disabled. In this
case the mic is always on and the slider switch
and button are ignored.
40-SW
45-NS
40-NS
9
Advertisement
