Keysight Technologies Y1248A Installation Manual

Keysight Y1248A and Y1249A
Multi-Site Signal Cable
Keysight's Y1248A and Y1248A Multi-Site Signal
Cables are the same cable but different lengths.
The Y1248A cable is 1 meter long and the
Y1249A cable is 2 meters long. These cables
separate the M9195A/B signals into four
independent partitions (banks) for multi-site
testing. Each partition contains a 20-pin Edge
Rate connector with squeeze latch, four signal
lines, four PMU sense lines, one high voltage,
and one open drain line. Each cable includes a
set of four alternate thumb screw hoods.
Refer to the M9195A/B Startup Guide and User Guide for detailed information on using the various signal lines.
General Use Recommendations
Keysight recommends that you use one of the following three Samtec
your Device Under Test (DUT) end connector on the cable:
ERF8-010-01-L-D-RA-L-TR (right angle)
ERF8-010-01-L-D-EM2-TR (edge mount, for use on 0.062"thick PC boards)
ERF8-010-05.0-L-DV-L-TR (vertical mount)
Installation and Removal of the Y1248A/Y1249A Cable
The end of the cable that connects to the M9195A/B has a single thumb screw on the hood. Connect the cable
to the M9195A/B and then hand-tighten the thumb screw to the attached nut on the module. See the
following photographs.
Samtec, http://www.samtec.com
1
1 20-pin mating connectors to mate with
Hand tighten thumbscrew
Optional
thumbscrew
hoods