Keysight Technologies Y1245A Installation Manual

Keysight Y1245A, Y1246A and Y1247A
Single Site Signal Cable
Keysight's Y1245A, Y1246A and Y1247A are the same
cable but different lengths; the Y1245A cable is 0.5
meters long, the Y1246A cable is 1 meter long and the
Y1247A cable is 2 meters long. These cables contain 60
micro coax lines for 16 channels, 16 PPMU sense, 4 high
voltage, and 4 Open Drain lines. 60-Pin Male Edge Rate
to Male Edge Rate connectors with squeeze latches are
used on the cable. The cables also include an alternate
thumb screw hood. One end of this cable plugs onto the
M9195A/B front panel connector. The other end is
available to connect to your Device Under Test (DUT) or
the Keysight Y1253A Evaluation and Prototyping Kit.
Refer to the M9195A Startup Guide and User Guide for detailed information on using the various signal lines.
General Use Recommendations
Keysight recommends that you use one of the following three Samtec
your Device Under Test (DUT) end connector on the cable:
ERF8-030-01-L-D-RA-L-TR (right angle)
ERF8-030-01-L-D-EM2-TR (edge mount, for use on 0.062"thick PC boards)
ERF8-030-05.0-L-DV-L-TR (vertical mount)
Installation and Removal of the Y1246A/Y1247A Cable
The end of the cable that connects to the M9195A has a single thumb screw on the hood. Connect the cable to
the M9195A/B and then hand-tighten the thumb screw to the attached hex standoff on the module. See the
following photographs.
1 Samtec, http://www.samtec.com
Optional
thumbscrew hood
60-pin mating connectors to mate with
1
Hand tighten thumbscrew