Connecting Internal Signal Cables
3.3
The protective housing of the communications terminal delivered with the device can be
•
fastened with clips or screws based on the actual diagram.
•
Install signal cables with a diameter of 5 mm and rubber plugs as described in this section. Do
not use signal cables with a diameter of 7 mm.
Securing With Clips
When a communications terminal is connected to a single network cable, a waterproof rubber
•
plug must be installed. Do not install a cable with a diameter of 5 mm into a Ф7 mm rubber
plug.
After inserting the terminal shell into the COM port, shake the terminal shell left and right
2
•
and pull it back to ensure that it is securely installed, and tighten the nut (ensure that the
rubber plug is tightly compressed). Otherwise, the waterproof performance is affected.
Terminal of
battery
modules
11
Terminal of
power
module
Click