Advertisement
1.
Getting to know your device
Maximum load total for the wireless-controlled outlets: 600 watts (Incandescent); 1800W (15A)
•
Resistive or 1/2 HP Motor
Both outlets are controlled simultaneously
•
Remote ON/OFF control through other Control4 devices
•
Manual ON/OFF control with the front panel push button
•
Over-the-air updates — Once joined to your Control4 Zigbee network, the Plug-In Outlet Switch can
•
transparently receive updates through your Control4 controller
LED status indicator — Indicates light status and status during network pairing process
•
Space-efficient design
•
Does not block the lower outlet when plugged in to the upper outlet of a duplex wall receptacle.
•
(This assumes that the duplex receptacle is mounted with the ground pin down.)
Plugs and cords for connected devices route to the side, allowing close placement of furniture
•
3.
Note: For best results, please run OS 3.1.2 or newer.
1. Plug the lights you plan to control into the outlets on the Plug-In Outlet
Switch.
2. Plug the Plug-In Outlet Switch into an available outlet.
Note: Plug directly into outlet. Do not use with extension cords.
3. In Composer, add the driver for the Plug-In Outlet Switch
(C4-V-OSW120) to the project.
4. In the Network > Zigbee Network view, double-click the driver for the
Plug-In Outlet Switch to open the Identify window.
5. Follow Composer's on-screen instructions to identify the Plug-In Outlet
Switch; press the switch's Program button 4 times.
6. After the Plug-In Wireless Switch is joined to the Zigbee network, the
LED status indicator stops blinking, and the address for the Plug-In Outlet
Switch appears in Composer. The Plug-In Outlet Switch is now paired to
the Zigbee network and can be controlled.
2.
A
Note: The LED blinks until the switch is added to a Control4 project.
Note: If the switch does not successfully join the network, the auto-scan
process will eventually time out (and the LED status indicator will stop
blinking). To restart the pairing process following a timeout, press the top
button 4 times quickly.
If prompted to enter the install code, refer to the QR code label on
the product. Enter the full code.
EUI: 000D6FFFFECD6DD6
Example:
Install code: 39F9-0CA3-09F2-4C6F-
8080-131B-6EE4-1E95-D22E
B
A
4.
Remove from Zigbee network
From Composer
In Composer under Network > Zigbee Network, select the Plug-In Outlet Switch and
click on Disconnect. The Plug-In Outlet Switch will be removed from the Zigbee network.
All configuration parameters will be reset after the Plug-In Outlet Switch is removed from
the network.
Manual Reset
To manually reset and remove the Plug-In Outlet Switch from the Zigbee network, press
the Program button 13 times quickly (short presses).
A. Two wireless controlled outlets
Both outlets can simultaneously remotely turn on/off two
connected lamps
B. Program button
Single press — Turn the lamp On/Off
9 quick, short presses — Reset to factory defaults
(Reset Outlet Switch)
Advertisement
