Table of Contents
Advertisement
Setting the Shake Reduction Function
The [Input Focal Length] setting menu appears when the camera is turned
on with the Shake Reduction switch on and a type of lens that does not
support automatic acquisition of lens information such as focal length
(p.67) is mounted.
Set [Focal Length] manually on the [Input Focal Length] setting menu.
• The [Input Focal Length] setting menu does not appear when using a lens
that supports automatic acquisition of lens information such as focal length
because [Focal Length] is set automatically.
• When using a lens without the s position on the aperture or with the aperture
set to a position other than the s position, set [23. Using aperture ring] on
the [A Custom Setting] (p.76) menu to [Permitted].
1
Use the four-way controller
(45) or the e-dial to set [Focal
Length].
Select from the following 34 focal length
values. (The default setting is 35.)
8
10 12 15 18 20 24 28 30 35
40 45 50 55 65 70 75 85 100 120
135 150 180 200 250 300 350 400 450 500
550 600 700 800
• If the focal length for your lens is not listed above, select the value closest to
the actual focal length (example: [18] for 17 mm and [100] for 105 mm).
• When using a zoom lens, select the actual focal length at the zoom setting in
the same manner.
• Effect of Shake Reduction is influenced by the shooting distance as well as
focal length information. The Shake Reduction function may not perform as
expected when shooting at close ranges.
2
Press the 4 button.
The camera is ready to take a picture.
To change the Focal Length setting, use [Input Focal Length] on the [A Rec.
Mode] menu (p.74).
Input Focal Length
Focal Length
120
100
135
Cancel
MENU
69
3
OK
OK
Advertisement
Table of Contents
