Bison PR98SHT Instruction Manual

—— Instruction Manual ——
PR98SHT, PR98SHTJR
Bracket to install Steel Backboard on HangTime Systems
Item Qty Description
A 1 Steel Backboard**
B Extension Arm**
1
C 2 Parallel Linkage**
D 1 Rim**
E 1 Steel Board Bracket
F 1 Top Pivot Bolt**
G 1 Bottom Pivot Bolt**
H 2
Lock Nut**
 Inspect all contents prior to installation. Report any missing parts to dealer immediately
 Read all instructions before proceeding.
Follow the instructions provided with the HangTime pole system through instruction #9 to install/
assemble vertical pole and main extension arm assembly. Use these instructions in place of instruction
#10 to install the PR98SHT bracket and steel backboard. Continue with instruction #11 provided with
1. Use Bottom Pivot Bolt (G), Top Pivot Bolt (F) and Lock Nuts (H) to attach Steel Board Bracket (E) to
Extension Arm (B) and Parallel Linkages (C). Do not overtighten hardware, make sure the Extension Arm
(B) and Parallel Linkages (C) pivot and adjust up and down freely. See Figure 1.
2. Hang Steel Backboard (A) over the top lip of Steel Board Bracket (E). Use 7/16" X 1 1/2" Carriage Bolts
(I), 7/16" Flat Washers (J), 7/16" Lock Washers (K) and 7/16" Hex Nuts (L) in the top two holes of Steel
Backboard (A) and Steel Board Bracket (E). Hand tighten hardware at this time. See Figure 1.
3. Use 3/8" X 1 1/2" Hex Bolts (M), 3/8" Flat Washers (N), 3/8" Lock Washers (O) and 3/8" Hex Nuts (P) to
install Rim (D). Hand tighten hardware at this time. See Figure 1.
4. Level Steel Backboard (A) and Rim (D). Tighten all hardware.
Date: 12/21/2017 Rev: I.R.
AND
P A R T S L I S T
**Packaged Separately
the HangTime pole system to complete assembly.
B.A. N.J.C.
PR98SXLHT
Item Qty Description
I 2 7/16" X 1 1/2" Carriage Bolt
J 2 7/16" Flat Washer
K 2 7/16" Lock Washer
L 2 7/16" Hex Nut
M 4 3/8" X 1 1/2" Hex Bolt
N 8 3/8" Flat Washer**
O 4 3/8" Lock Washer**
P 4 3/8" Hex Nutt**
Notice:
File: \pub\inst\pr98shtinst
1
Customer Service
(800) 247-7668
.
Ref#: 920414