Step 7. Create And Run Flexoto Test Plans - Keysight Technologies N1002A Quick Start Manual

Step 7. Create and Run FlexOTO Test Plans

1. Click on a Station tab.
2. If you plan to remotely operate FlexOTO, turn on FlexOTO's SCPI Recorder
3. In the Test Program panel, click Add Lines 1. This opens the Test Program
N1002A Quick Start Guide
so that you can capture FlexOTO Station SCPI commands as you configure
the Test Program. The SCPI Recorder quickly lists the commands needed to
perform your tasks.
Measurement Setup dialog. In the dialog, configure your Test Plan and then
click Add Lines and Close to add the test lines 2. Each line defines a test of a
specific DUT Fixture/Lane combination.
3 Configuring the FlexOTO Application
43