Toro REELMASTER 6000 Series Operator's Manual page 10

Lubrication
GREASING BEARINGS, BUSHINGS AND
PIVOT POINTS
Each cutting unit has (6) grease fittings (Fig. 15) that
must be lubricated regularly with No. 2 General Purpose
Lithium Base Grease.
The grease fitting locations shown in Figure 15 are for
each side of the cutting unit.
Lubricating cutting units immediately
IMPORTANT:
after washing helps purge water out of bearings and
increases bearing life.
1. Wipe each grease fitting with a clean cloth.
Apply grease until pressure is felt against the
2.
handle.
Note: Apply grease to reel bearing cavities until a
small amount is evident at the inboard reel seal.
Wipe excess grease away.
3.
10
Figure 15