Advertisement
ADJUSTING CUTTING UNIT
ATTITUDE
(2-SCREW GAUGE BAR)
The cutting unit attitude may be adjusted or verified
using a gauge bar, Toro part no. 98-1852, which has two
screws and three hole locations. The second screw is
used in the inner hole to set or verify cutting attitude.
Adjust as follows:
Set the front screw height to the final height-of-cut
1.
setting (Fig. 12).
Set the rear screw, distance "B", lower than the
2.
front setting (Fig. 12).
.20" (5.3mm)
.15" (3.8mm)
.09" (2.3mm)
.04" (1.0mm)
1. Adjust for final height-of-cut setting
3.
Place a gauge bar across front and rear rollers. The
front screw head should fit snugly over the edge of
the bedknife and the end of the rear screw should
contact the bottom of the bedknife (Fig. 13 & 14).
Front and rear rollers should contact the gauge bar.
Verify attitude at each end.
8
8
6
4
2
1
Figure 12
Figure 13
1. Bedknife
Figure 14
1
Advertisement
