H3C WX Series Getting Started Manual page 17

Required: Create a WLAN-ESS interface. If the WLAN-ESS interface identified by the
1.
interface-number argument does not exist, this command creates the WLAN-ESS
interface first.
[Sysname]interface wlan-ess interface-index
Required: Exit interface view.
2.
[Sysname]quit
Required: Create a WLAN service template. By default, no service template is
3.
created.
[Sysname]wlan service-template service-template-number { clear | crypto }
Required: Specify the service set identifier (SSID). By default, no SSID is set.
4.
[Sysname]ssid ssid-name
Optional: Bind the WLAN-ESS interface to the service template. By default, no
5.
WLAN-ESS interface is bound to the service template.
[Sysname]bind wlan-ess interface-index
Required: Enable the authentication method. By default, open system
6.
authentication is enabled. You can enable open system authentication, shared
key authentication, or both.
[Sysname]authentication-method { open-system | shared-key }
Required: Enable the service template. By default, the service-template is disabled.
7.
[Sysname]service-template enable
Required: Exit interface view.
8.
[Sysname]quit
Configuring an AP
Required: Specify the AP name and its model number and enter AP template view.
1.
The model number must be specified only during new AP template creation.
[Sysname]wlan ap ap-name model model-name
Required: Exit interface view.
2.
[Sysname]quit
Required: Enable WLAN radios. By default, no WLAN radio is enabled.
3.
[Sysname] wlan radio { disable | enable } { radio-policy radio-policy-name |
all | dot11a | dot11an | dot11b | dot11g | dot11gn }
Configuring the radio of an AP
Required: Enter AP template view.
1.
[Sysname]wlan ap ap-name model model-name
17