Set-Up - Vaillant VR 91f Operating And Installation Instructions

Information on the
data plate
LR06
T60
3.2.2 CE marking
The CE marking shows that the products
comply with the basic requirements of the
applicable directives as stated on the de-
claration of conformity.
The manufacturer hereby declares that the
type of radio equipment that is described
in these instructions complies with Direct-
ive 2014/53/EU. The complete text for the
EU Declaration of Conformity is available
at: http://www.vaillant-group.com/doc/doc-
radio-equipment-directive/.

3.3 Set-up

3.3.1 Checking the scope of delivery
Quant- Contents
ity
1 Remote control unit
1 Fastening material (2 bolts and 2
wall plugs)
4 Batteries, LR06
1 Documentation
3.3.2 Requirements for lines
▶
Use standard commercial lines for the
wiring.
– Minimum cross-section: ≥ 0.75 mm²
– Maximum line length: ≤ 125 m
0020253110_03 Operating and installation instructions
Meaning
Read the instructions
Battery type designa-
tion
Max. permitted envir-
onmental temperat-
ure: 0 to 60 °C
3.3.3 Requirements for determining
the reception strength of the
remote control
– The set-up and installation of all sys-
tem components and the radio receiver
unit (except for the system control and
the outdoor temperature sensor) is com-
plete.
– The power supply for the entire heating
installation is switched on.
– The system components are switched
on.
3.3.4 Installing the remote control
Determining the installation site of
the remote control in the building
1. Choose an installation site that meets
the following requirements.
– Interior wall of the main living room
– Installation height: 1.5 m
– not in direct sunlight
– not affected by heat sources
Determining the reception strength
of the remote control at the chosen
installation site
2. Observe all the points listed in "Re-
quirements for determining the re-
ception strength of the remote control
(→ Page 11)".
3. Stand next to the radio receiver unit.
B
4. Open the remote control's battery
compartment as shown in the figure.
A
!
11