SOMFY J4 io Protect Short Installation Manual

EN
J4 io Protect
Short installation guide
O
RIGINAL INSTRUCTIONS
Complete instruction guide available online on www.somfy.info
N
L
OFF
1

PREPROGRAMMING A CONTROL POINT

2
UP
3
Factory setting :

SETTING THE UPPER END LIMIT

Ensure that the EVB is at least 15 cm below the new desired upper end limit.
1
Other setting like Tilting travel, Obstacle detection, Automatic adjustment and more are available from the "Help me by Somfy" application
4
UP
230 V 50 Hz
N Blue
L Brown
Green - Yellow
10 min
Control point is temporary
programmed for 10 minutes.
PROG.
0.5 s

END LIMITS SETTING

the drive is supplied in lower end limit position. The mushroom can therefore be used to set the upper end limit position.
A minimum of 3 rotations of the drive shaft is required between the lower end limit and the upper end limit.
2
This drive does not require any maintenance operation
DOWN
N L
DIRECTION OF ROTATION

PAIRING

Control point is completely
programmed.
3

USE

STOP
From the Application
"Help me by Somfy"
scan the QR code here
to find complete
setting instructions.
"Help me by Somfy"
available on stores
2
You can go
to the step
DOWN
4
MY