Bante Instruments PHscan10 Instruction Manual

Pocket ph tester

Download this manual

Hazardous Substance Statement

Bante is committed to the reduction and eventual elimination of all hazardous

substances in both the manufacturing process and finished products we supply.

We have an active manufacturing and procurement program to minimize and

eliminate the use of harmful heavy metals such as cadmium, lead, mercury and

the like.

New technologies and design parameters are also promoting these efforts and

we expect to have little or no such materials in our product in the coming years.

We welcome our customers suggestions on how to speed up these efforts.

Warranty

The warranty period for PHscan series tester is 12 months from the date of

shipment. Above warranty does not cover pH electrode module and calibration

solutions. For more information, please contact nearest authorized distributor.

BANTE INSTRUMENTS LIMITED

E-mail: banteinstruments@yahoo.com

Phone: 0086-21-6404-1598

Website: www.bante-china.com

The information in this document is subject to change without notice.

PHscan10 Pocket pH Tester

Instruction Manual

BANTE INSTRUMENTS LIMITED

Technology to create the future...

Need help?

Do you have a question about the PHscan10 and is the answer not in the manual?

Page 1 For more information, please contact nearest authorized distributor. BANTE INSTRUMENTS LIMITED E-mail: banteinstruments@yahoo.com Phone: 0086-21-6404-1598 Website: www.bante-china.com BANTE INSTRUMENTS LIMITED The information in this document is subject to change without notice. Technology to create the future... Copyright © Bante Instruments Limited, 2013. All rights reserved.
Page 2 Prior to Use Introduction — Remove the electrode protective cap from tester. Thank you for selecting the PHscan10 pocket pH tester. This manual provides a step-by-step guide to help you operate the meter, please carefully read the following instructions before use.
Page 3 PHscan10 PHscan10 Power On/Off 5. Press ENTER key to confirm. W ait for the measured value to stabilize, the reading will flash 3 times indicating that first calibration point is completed. — Press MEAS key to turn on the tester, the meter shows measured values.
Page 4 PHscan10 PHscan10 pH Measurement Troubleshooting Rinse the electrode thoroughly with distilled water, press MEAS key to turn LCD DISPLAY CAUSE on the tester. — Electrode dried out. 2. Dip the electrode into the sample solution, stir the tester gently. Soak the electrode module in tap water for 10 minutes.