Advertisement
STANDARD INSTALLATION INSTRUCTIONS
STEP 1 - CABINET OR WALL OPENING
The opening in the wall or cabinet must be within the following
dimensions:
OPENING
Height (A)
14
Width (B)
24
Minimum Depth (C)
20" (508 mm)
Outlet should NOT be in the shaded area as indicated in
Figure 1.
A
B
NOTES
• Please allow minimum 3" wood gap between the
microwave oven cutout and the appliance cutout below
the microwave oven. See Figure 2.
Microwave cutout
Wall oven cutout
SKM427F9HS, SKM430F9HS
1
3
/
" - 15
/
" (368.3 - 400 mm)
2
4
3
/
" (628.7 mm)
4
C
FIGURE 1
3" Min.
FIGURE 2
• If the dimension of DEPTH (C) is more than 21" (533.4
mm), the outlet location may be any area on the rear wall.
• The floor of the opening should be constructed of plywood
strong enough to support the weight of the oven and floor
load (about 100 lb/45 kg). The floor should be level and
90˚ with the face of the cabinet for proper installation and
operation of the oven. Check the local building code that
may require the opening be enclosed with sides, ceiling
and rear partition. The proper functioning of the oven
does not require the enclosure.
STEP 2 - EXHAUST DUCT ASSEMBLY INSTALLATION
1. Place the EXHAUST DUCT ASSEMBLY in the center of
the opening. Align the front edge of the duct with the front
of the cabinet.
2. Secure the EXHAUST DUCT ASSEMBLY with 2 SCREWS
D. See Figure 3.
Screw D
Screw D
C L
STEP 3 - FRAME INSTALLATION
1. Place the oven adjacent to the wall or cabinet opening.
Plug the POWER CORD into the electrical outlet.
2. Carefully guide the assembled oven into the prepared
opening. Slide the oven onto the EXHAUST DUCT
ASSEMBLY. Avoid pinching the cord between the oven
and the wall. See Figure 4.
Adjust the position of the oven so the feet of the oven
are fitted into the recesses of the EXHAUST DUCT
ASSEMBLY and the door opens properly. See Figure 5.
2
Exhaust duct
assembly, align
to front edge of
cabinet
FIGURE 3
Advertisement
