Husqvarna BMC 335 Operator's Manual page 13

8. Install the side cover.
9. Install the support plate.
10. Do a check of the drive belt tension. Refer to
check of the drive belt tension on page 22 .
Diamond blades and spacers for different
operation widths
Operation width, Quantity of dia-
mm mond blades
340
300
250
200
150
100
50
To adjust the height of the front wheels
The standard position is (B). Position (A) is used for
operation at maximum depth. Position (C) is used for
operation at minimum depth.
1816 - 002 - 22.03.2023
To do a
Quantity of
spacers, 2.5 mm
80 85
71 92
59 100
47 108
35 116
24 125
12 133
1. Loosen the bolts (D) on each side of the front wheel
bar.
D
2. Turn the nut (E) to set the applicable height.
3. Tighten the bolts (D) on each side of the front wheel
bar.
A
B
C
D
E
13