Husqvarna TS 112 Operator's Manual page 26

a) Remove the clip (A) and the washer (B).
b) Disconnect the front link (C) from the bracket (D)
on the cutting deck.
8. Do the steps that follow to disconnect the 2 rear
links. There is one rear link on the left side and one
rear link on the right side of the product.
WARNING:
heavy. Use a crowbar or equivalent
below the cutting deck to hold the weight
of the cutting deck when you disconnect
the 2 rear links.
a) Remove the clip (E), the washer (F) and the pin
(G) on the left and the right side.
G
E
F
b) Move the cutting height lever to the highest
position.
9. For the TS 112 model, do the steps that follow to
disconnect the clutch cable.
26
B
A
C
D
The cutting deck is
a) Disconnect the clutch cable (H) from the spring
(I) on the belt tensioner.
b) Remove the clip (J) and pull out the clutch cable
holder (K) from the bracket on the cutting deck.
J
10. Remove the cutting deck from the product.
11. Install the cutting deck in the opposite sequence.
CAUTION:
belt is installed correctly and does not
get compressed when you install the
cutting deck.
a) Make sure that the brackets are in the correct
position when you install the cutting deck. The
bracket on the right side (A) must be on the inner
side of the right rear link. The bracket on the left
side (B) must be on the outer side of the left rear
link.
B
I
H
K
Make sure that the drive
A
1825 - 003 - 08.02.2023