Handle - Murray M26-T Instruction Manual

ASSEMBL YPROCEDURES
Shaft Assembly
Fig.1
Fig.3
Assembling the split shaft
1. Slacken the star grip screw (1) on the split shaft connection. (see Fig 1)
2. Then press lever on the shaft split connection (2) and carefully slide the lower haft (4)
into the shaft split connection (3). (see Fig 1 & 2)
NOTE: When doing so, take care to ensure that the drive shafts on the insides
of the tubes slide into each other, (turn the trimmer head gently if required)
3. Ensure that the lever on the shaft split connection locks into the corresponding hole (5).
(see Fig 3)
4. Then re tighten the star grip screw (1). (see Fig 4)
5. To dismantle, proceed in reverse order.
Clasic Handle
Fitting the handle
1 Slacken the wing nut on the fastening screw on the handle.
2 Remove the wing nut, washer and fastening screw from the handle.
3 Push the Classic handle onto the shaft.
4 Replace fastening screw and tighten with the wing nut.
16
NOTE: Not too loose or too tight. Over tightening may damage the unit
Fig.2
Fig.4