Miele KM 6565 FR Operating And Installation Instructions page 25

Con@ctivity via a direct WiFi
connection (Con@ctivity 3.0)
Requirements:
- The WiFi stick supplied with your
appliance must be fitted
- WiFi-enabled Miele cooker hood
You can find the necessary
information on connecting the cooker
hood in the associated operating and
installation instructions.
 Switch the hob on.
 Touch the 0 sensor control on any of
the numerical displays.
 Touch and hold the 0 and 7 sensor
controls on the numerical display at
the same time for 6 seconds.
The seconds can be seen counting
down in the timer display. After the time
has elapsed, a progress light appears in
the timer display during the connection
attempt. If the connection was
successful, the code : appears in
the timer display. If the connection
could not be established, the timer
display will show the code :. Repeat
the steps above.
When successfully connected, 2 and
3 will light up constantly on the cooker
hood.
 Quit connection mode on the cooker
hood by pressing the run-on 
button.
Con@ctivity is now activated.
Before using for the first time
With a direct WiFi connection, it is not
possible to connect the hob and the
cooker hood to a home network. If this
is desired later, the direct WiFi
connection between the hob and the
cooker hood must first be
disconnected (see "Initial
commissioning – Con@ctivity" and
"Disconnecting the WiFi" in the
operating and installation instructions
for the cooker hood).
25