Table of Contents
Advertisement
TO INSTALL BOWL
Carefully align and lower the bowl. Apply weight to the bowl
rim to insert drain outlet into the P-trap.
When the bowl is completely set on the ground, check
whether there is interference or gap between the bowl or
water tank and the wall.
It is recommended that the bowl or tank is just in contact with
the wall.
If there is interference or gap between the bowl or tank and
the wall, lift up the bowl, re-adjust the distance between the
drain pipe and the wall, and then install the bowl.
For best result, make sure the bowl is level when installing.
Carefully thread the screws into the L-shaped fitting, until
toilet is secure. Alternately tighten left and right sides to
prevent pulling the toilet off center. Install cap to cover screw.
Do not overtighten.
Apply caulk around base.
Outlet
P-trap
Fig.#11
11
TO CONNECT WATER
SUPPLY
* Flexible hose (not provided) are
recommended to connect the supply
line to the fill valve. If you use a rigid
connection(not provided), take care
not to apply side forces to the bottom
of the fill valve. Be sure the rigid
connection must be fit with supply line
completely to prevent damage shank
by forced connection.
IMPORTANT:
Before turning on the supply valve for the first
time, follow the steps below to clear sand, debris and rust
from the system:
Make sure water supply is off. Remove valve END by
rotating it 1/8 turn counterclockwise.
While holding a container over the uncapped VALVE to
prevent splashing, turn water supply on and off a few times.
Leave water supply off.
Replace END by engaging lugs and rotating 1/8 turn
clockwise.
Make certain the top is turned to the locked
position. Valve may not turn on if top is not fully in the
locked position.
Turn on water supply. Check that water level is at the marked
water line.
1505361-T2-A
Bushing
Screw
Cap
Fig.#12
12
Supply Shank*
Supply Shut-Off Valve
Fig.#14
14
-5-
L
Fig.#13
13
(
(
)
1/8
1/8
12
)
Advertisement
Table of Contents
