Setting Power Mode - Bowers & Wilkins CDA-2HD Manual

5. Setting POWER MODE

CDA-2HD can be set up to automatically power on
when needed. The POWER MODE can be selected
via the Product Configuration Page, allowing the
CDA-2HD to be powered on at all times when
POWER MODE is set to ON. The CDA-2HD can also
be turned on when an audio signal is present at any
audio input by selecting AUTO DETECT or the
12V TRIGGER.
To set up CDA-2HD to be controlled by a 12V
trigger:
1. Connect the 12V trigger cable to the 3.5mm
12V TRIGGER IN socket, see Diagram 12.
Ensure a 12V signal is present.
2. Select 12V TRIGGER in the
POWER MODE settings
3. (Optional) Connect the 12V TRIGGER OUT
socket to a 12V TRIGGER IN on another
amplifier to link the power control together
In this mode, CDA-2HD will turn on when a 12V
signal is present on the 12V Trigger Input. This 12V
trigger input can be wired to the 12V trigger output
from an audio matrix switch or a relay.
Note: All amplifier zones turn on when a 12V
trigger is received in 12V TRIGGER MODE.
6. Network Connection Instruction
6.1 Connecting to your Product
Configuration Page
1. The amplifier's factory default settings has
DHCP set to ON.
2. Connect the amplifier to a network with a router
using a RJ-45 cable. Make sure the computer /
tablet and amplifier are on the same network.
3. Turn on the amplifier.
4. Open a web browser.
5. Enter the CDA-2HD default network address
[product name]+[serial number] for example:
http://cda-2hd_XXXX-xxxxxxx.local in the
browser address field and press "return". This
will open the Product Configuration Page.
Alternatively, all network IP addresses will be
accessible from your Router configuration page.
Diagram 12. 12V Trigger
Model: CDA-2HD
Part Number: FPXXXXX
Serial Number: YYWW - XXXXXXX 5555-0000001
MAC Address: XX:XX:XX:XX:XX:XX
This device complies with part 15 of the FCC rules and Industry Canada's license-exempt RSSs. Operation is subject
to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept
Audio Amplifier
any interference received, including interference that may cause undesired operation. Made in Thailand.
E496941
This device complies with part 15 of the FCC rules and Industry Canada's license-exempt RSSs. Operation is subject
to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation. Made in Thailand.
Diagram 13. Product label – Serial Number
180º
Model: CDA-2HD
Part Number: FPXXXXX
5555-0000001
Serial Number: YYWW - XXXXXXX
MAC Address: XX:XX:XX:XX:XX:XX
Audio Amplifier
E496941
Internet browser
Internet browser
http://cda-2hd_5555-0000001.local
http://cda-2hd_5555-0000001.local
180º
8