MULTIQUIP Mikasa Series Operation Manual page 24

ENGINE OIL
NOTICE
Drain the engine oil when the oil is warm.
1. Remove the oil drain bolt (Figure 25). and allow the oil
to drain into a suitable container.
DIPSTICK
OIL FILLER
CAPS
Figure 25. Draining Engine Oil
2. Replace engine oil with recommended type oil as listed
in Table 5. For engine oil capacity, see Table 2 (Engine
Specifications). DO NOT overfill.
3. Reinstall drain bolt and tighten securely.
PAGE 24 — MVH508GV PLATE COMPACTOR • OPERATION MANUAL — REV. #0 (05/01/23)
SPARK PLUG
OIL FILLER
CAP
OIL DRAIN
BOLT
HYDRAULIC OIL
4. With the handle in the operating position, remove the
plug cap from the hydraulic pump (Figure 26).
BREATHER PLUG
(24mm wrench)
PLUG CAP
HAND PUMP
Figure 26. Removing Plug/Breather Cap
5. Remove the breather plug with a 24 mm wrench at the
top of the hydraulic pump.
6. Remove the hydraulic hose connected to the cylinder
on the vibrator side (Figure 27).
Hydraulic hose
Cylinder
Figure 27. Removing Hydraulic Hose
7. With the direction control lever at the forwardmost
position, secure the guard frame with a rope to
immobilize (Figure 28).
Direction
Figure 28. Direction Control Lever
(Forward Position)
MAINTENANCE
OIL LEVEL
OIL LEVEL OIL LEVEL
Air releasing plug
Forward-most position
Guard frame
control lever