MULTIQUIP Mikasa Series Operation Manual page 22

MACHINE INSPECTION
Perform machine inspection as listed in Table 6.
Table 6. Machine Inspection
Interval
Fuel Tank For Leaks
Fuel System for Leaks
Air Cleaner Element
Guard Frame
Daily Before Starting
Shock Absorber
Hydraulic pump
Hydraulic Pipe System
Direction Control Lever
Every 20 Hours Engine Oil/Oil Filter
Engine Oil Filter
Every 100 Hours
Hydraulic Oil
Every 200 hours
Engine Bolts
Every 300 hours
Hydraulic Oil
Engine Oil Filter
Every 2 years
PAGE 22 — MVH508GV PLATE COMPACTOR • OPERATION MANUAL — REV. #0 (05/01/23)
Check Solution
Machine Clean if necessary.
Repair fuel leaks.
Repair fuel leaks.
Engine Oil Add oil if necessary.
Vibrator Oil Add oil if necessary.
Clean/Replace
Inspect/deformations
Replace if damaged.
Check/Repair Leaks
Check/Repair leaks,
Inspect for wear
Check bolts/nuts,
Inspect for wear
Check for crack/
Duct Hose
damage
Replace only after
first 20 hrs.
Engine Oil Change
Wash
Check oil level.
Vibrator Oil
Check for leaks/dirt.
Check oil level.
Check for leaks.
Inspect, replace if
V-Belt
damaged or worn.
Inspect, replace if not
Clutch
working properly.
Replace bolts
if deformed or
elongated.
Vibrator Oil Change
Fuel Filter Change
Change
Change
Fuel Lines Replace
TIGHTENING TORQUE
Reference Table 7 below (Tightening Torque ), for re-
tightening of nuts and bolts.
Table 7. Tightening Torque (in. kg/cm)
Material
6mm 8mm 10mm
4T 70 150 300
6-8T 100 250 500
11T 150 400 800
100 (6mm) 300 ~ 350 (8mm) 650 ~ 700 (10mm)*
* In case material is aluminum
Bolt threads used with this machine are all right handed
Material and quality of material is marked on each bolt, and screw.
FRONT COVER OPENING
For ease of inspection and maintenance, perform the
following:
1. Remove the bolts (M14 x 45) on the front cover. Loosen
the bolts (M14 x 45) on the side of front cover without
removing them
Remove Bolts on
top of front cover
Loosen Bolts on
side of front cover
Figure 21. Removing/Loosening Bolts
2. Hold the side of the front cover and pull up to open
position (Figure 22).
Figure 22. Pulling Up Front Cover
MAINTENANCE
12mm 14mm 16mm 18mm
500 750 1,100 1,400
800 1,300 2,000 2,700
1,200 2,000 2,900 4,200
OPEN POSITION
Pull up
20mm
2,000
3,800
5,600