Advertisement
12
Connect the wires to the female
connector insert (or male connector
insert) with a screw driver.
Screws must be closed using a torque of
0.8 Nm for pressure wire
15
Firstly, press the cable seal into the
connector housing until it stop and screw
the pressure nut on the connector
housing (Fig. 15.1)
Secondly (Fig. 15.2), tighten the pressure
nut using the appropriate tool to a
torque between 2.5 Nm and 4 Nm
13a
Insert the female connector insert in the
housing until it stop. Make sure the
housing's protrusion match with the
connector insert's cavity
16
Fig. 15.1
Fig. 15.2
For mating align the two half connectors
and mate them together by hand until
they stop (male and female connectors
incorporate keying features) (Fig. 16.1)
Screw the locking nut until it stop
(Fig. 16.2)
Fig. 16.1
Fig. 16.2
13b
The female connector insert and the
male connector insert can be inserted in
both connector housings (male or
female) depending on the application
needs.
17
Fig. 17.2
To un-mate connectors unscrew the
locking nut until it stops (Fig. 17.1)
Pull the connector housing apart (Fig.
17.2)
Fig. 17.1
Advertisement
