Download Print this page

Maintenance And Servicing - Bosch BPC3400 Original Operating Instructions

Ebike battery charger
Hide thumbs Also See for BPC3400:

Advertisement

Available languages

Available languages

Note: If you have charged the battery on the bike, carefully
close the charging socket (6) with the cover (7) after char-
ging, so that no dirt or water can get in.
Errors – causes and corrective measures
Cause
Battery defective
Battery too warm or too cold
The charger is not charging.
Charging not possible (no indicator on battery)
Connector not attached properly
Battery contacts dirty
Plug socket, cable or charger defective
Battery defective

Maintenance and servicing

Maintenance and cleaning
If the charger fails, please contact an authorised bike dealer-
ship.
After-sales service and advice on using products
If you have any questions about the eBike system and its
components, contact an authorised bicycle dealer.
For contact details of authorised bike dealerships, please
visit www.bosch-ebike.com.
Disposal
Chargers, accessories and packaging should be recycled in
an environmentally friendly manner.
Do not dispose of chargers along with household waste.
Check that your personal data has been deleted from the
device.
Please return Bosch eBike components that are no longer
usable free of charge to an authorised bicycle dealer or to a
recycling facility.
Subject to change without notice.
Bosch eBike Systems
If the charger is not disconnected from the battery after
charging, after a few hours the charger will switch itself back
on, check the state of charge of the battery and begin the
charging procedure again if necessary.
Corrective measures
Two LEDs flash on the battery.
Contact an authorised bike dealership.
Three LEDs flash on the battery.
Disconnect the battery from the charger until the charging
temperature range has been reached.
Do not reconnect the battery to the charger until it has
reached the correct charging temperature.
No LEDs flashing (one or more LEDs will remain perman-
ently lit depending on the state of charge of the eBike bat-
tery).
Contact an authorised bike dealership.
Check all connections.
Carefully clean the battery contacts.
Check the mains voltage, have the charger checked over by a
bike dealership.
Contact an authorised bike dealership.
English – 3
0 275 007 3CX | (04.07.2022)

Advertisement

loading

This manual is also suitable for:

Bpc3430