Maintenance And Servicing; Maintenance And Cleaning - Bosch BCS220 Original Operating Instructions

The charging process begins as soon as the charger is
connected to the battery or charging socket on the bike
and to the mains.
Note: The charging process is only possible when the
temperature of the eBike battery is within the permitted
charging temperature range.
Note: The drive unit is deactivated during the charging
process.
The battery can be charged with or without the on-
board computer. When charging without the on-board
computer, the charging progress can be observed via the
battery charge indicator.
When the on-board computer is connected, a charging
notification appears on the display.
The state of charge is displayed by the battery charge indic-
ator (9) on the battery and by the bars on the on-board
computer.
The LEDs on the battery charge indicator (9) will flash
during the charging process. Each solid illuminated LED
represents approximately 20 % of the charging capacity.
The flashing LED indicates the next 20 % currently
charging.
Once the eBike battery is fully charged, the LEDs
extinguish immediately and the on-board computer is
switched off. The charging process is terminated. The
state of charge can be displayed for three seconds by
pressing the on/off button (10) on the eBike battery.
Disconnect the charger from the mains and the battery
from the charger.
When the battery is disconnected from the charger, the
battery is automatically switched off.
Note: If you have charged the battery on the bike,
carefully close the charging socket (6) with the cover (7)
after charging, so that no dirt or water can get in.
If the charger is not disconnected from the battery after
charging, the charger will switch itself back on after a
few hours, check the state of charge of the battery and
begin the charging process again if necessary.
Errors – causes and corrective measures
Charging not possible (no indicator on battery)
Connector not attached
properly
Battery contacts dirty
Cause
Bosch eBike Systems
Check all connections.
Carefully clean the battery
contacts.
Corrective measures
Socket outlet, cable or
charger defective
Battery defective

Maintenance and servicing

Maintenance and cleaning

If the charger fails, please contact an authorised bike
dealership.
After-sales service and advice on using
products
If you have any questions about the charger, contact an
authorised bike dealership.
For contact details of authorised bike dealerships, please
visit www.bosch-ebike.com
Disposal
Chargers, accessories and packaging should be recycled
in an environmentally friendly manner.
Check the mains voltage,
have the charger checked
over by a bike dealership.
Contact an authorised
bike dealership.
English – 3
0 275 007 XCX | (24.04.2018)