Perform Connection / Disconnection Commands (Update) - Racal Instruments 1258 Manual

1258 User Manual
Perform
connection /
disconnection
commands
(UPDATE)
Keypad Lock and
Unlock
Commands
(LOCK and
UNLOck)
Racal Instruments © 2005
With the AutoUpdate mode disabled (default), Open and Close
commands cause the specified connections to be placed on
connect or disconnect lists. The UPDATE command causes all
pending connections and disconnections to be performed. This
allow simultaneous connections to be performed on multiple
routes. To prevent any signal contention, disconnections are
performed first, followed by all connections.
Syntax:
UPDAte
Examples:
UPDATE - performs all connects and disconnects present on
their respective list.
The LOCK command is used to prevent inadvertent keypad entry.
With the keypad locked, an operator is required to press Smartkey
A, then press ENTER within 2 seconds, to unlock the keypad. This
lock feature is not designed as a security device, it is only
designed to prevent accidental keypad entry.
command allows the remote computer to unlock the keypad. The
LOCK command is only available through a remote interface.
Syntax:
LOCK
UNLOck
Examples:
LOCK - locks the keypad.
UNLOCK - unlocks the keypad
The UNLOck
Operating Instructions 4-13