Table of Contents
Advertisement
1258 User Manual
Disconnect
commands
(OPEN)
Connect
commands
(CLOSE)
Racal Instruments © 2005
The OPEN command specifies routed connections to be
disconnected.
Connections specified are placed on the
disconnection list.
disconnect(s) are performed immediately. Otherwise (default) the
disconnection(s) are not performed until the UPDATE command is
received.
Syntax:
[ROUTe:]OPEN(@channel_list) or [ROUTe:]OPEN:ALL
Examples:
OPEN(@15!47) - place connection input 15 to output 47 on the
disconnect list.
ROUTE:OPEN:ALL - place all connections on the disconnect
list.
The CLOSE command specifies routes to be connected.
Connections specified are placed on the connection list.
AUTOupdate is enabled, then the connection(s) are performed
immediately.
Otherwise (default) the connection(s) are not
performed until the UPDATE command is received.
Syntax:
[ROUTe:]CLOSe(@channel_list)
Examples:
CLOS(@15!47) - place connection input 15 to output 47
on the connect list.
ROUTE:CLOSE(3!18,7!39), -
input 3 to output 18, and input 7 to output 39 on the
connect list.
If AUTOupdate is enabled, then the
place
Operating Instructions 4-11
If
connection
Advertisement
Table of Contents
