1258 User Manual
Remote Operation
Interface
Configuration
Commands and
Queries
Racal Instruments © 2005
Figure 4-6. Example With Diagnostic Mode Enabled
Before using remote operation, the interface must be configured
using the front panel user interface. See Configuring Remote
Control Interfaces for instructions on configuring the GPIB,
Ethernet, and RS-232 interfaces.
accepts standard ASCII character strings for control and status
requests. The 1258 uses a SCPI type command structure and
format, though full SCPI compliance is not guaranteed.
The <channel_list> parameter is a single input/output route
specification or a list of input/output routes separated by commas.
Each input/output route is specified by using the syntax:
<input_channel>!<output_channel>.
Once configured, the 1258
Operating Instructions 4-9