Table of Contents
Advertisement
1258 User Manual
Configuring Operating
Modes
MultiConnect
Mode
PowerUp
Configuration
AutoUpdate
Racal Instruments © 2005
MultiConnect Mode is used to connect an input to more than one
output. When switching from MultiConnect to SingleConnect Mode,
all connections are disconnected. If MultiConnect is disabled and
an attempt is made to connect one input to more than one output,
the input will be disconnected from its previous output and then
connected to the latest output. See Configuration Commands and
Queries for details on executing this command remotely.
The PowerUp Configuration is used to store settings so the 1258
will startup with the preferred configuration. These settings include
all connections, modes and options. There are three modes to
choose from: Default, Current, and Last Configuration. The default
mode will startup with factory settings. Current configuration mode
will startup with all settings as they were when the enter button
was pressed while invoking Current Configuration mode. Last
Configuration mode will startup with all settings as they were when
the power was turned off.
Queries for details on executing this command remotely.
With AutoUpdate disabled (default), Open and Close routes are
placed on Connect and Disconnect lists. The matrix is physically
updated simultaneously, with the Update routes command. With
AutoUpdate mode enabled, all connections and disconnection's
are done immediately after Connect or Disconnect is selected or
the Open or Close command is received. In Auto Update mode
selecting Update Routes or sending the Update command is not
required. AutoUpdate mode can only be saved when the PowerUp
mode is 'Current' or 'Last Configuration'.
Commands and Queries for details on executing this command
remotely.
See Configuration Commands and
See Configuration
Operating Instructions 4-7
Advertisement
Table of Contents
