Table of Contents
Advertisement
Maintance
If used as prescribed on this manual, the equipment does not require a
specific routine maintenance.
In case of malfunctioning problems, please follow these simple instructions:
1.
check that the power outlet to which the appliance is connected
works regularly by connecting another working device;
2.
check the connection with the power supply and the integrity of all
the connection cables;
3.
check the connection with the applicator;
4.
make sure that all the operations have been properly done;
5.
verify every two years the device and its full functionality (by
contacting the manufacturer).
If you are experiencing any problems or if you need any further information,
please contact the manufacturer immediately.
FUNCTIONING CONTROL
MAG700 is equipped with a magnet (small ring or metal or metal/plastic
disc) in order to control the device functioning.
Control procedures:
1. switch on the appliance according to all the safety requirements
defined in this manual;
2. activate any therapy in accordance to user manual instructions;
3. get the supplied magnet and place it close to the applicator;
4. check the vibration of the magnet (it will be proportional to the
frequency of the selected therapy).
Please contact the manufacturer in case of magnet vibration absence.
CLEANLINESS
It is suggested to remove any trace of dust after each use of the device (and
its accessories) by using a soft dry cloth.
To clean the elastic therapeutic belt with 2 solenoids, it is recommended to
disconnect the applicator from the device before performing any operation,
then remove the 2 solenoid cable by removing the 2 silver studs with a
screwdriver.
Clean the tissue using water and mild soap and wait for the complete drying
before reconnecting the applicators.
IACER Srl
Care of the device
20
MNPG69-09
Advertisement
Table of Contents
