Appliance Parts; Before First Use; Preparing The Appliance For Operation - Bosch Coffeexx plus TKM6 Series Instruction Manual

Congratulations on purchasing this
Bosch appliance. You have acquired
a high-quality product that will bring
you a lot of enjoyment.
This instruction manual describes the
following models: TKM600... series

Appliance parts

X Fig. A
1
ON/OFF switch (on the side)
2 Supply cord
3 Water tank
4 Water tank insert
5 Water tank lid
6 Control panel
7 Cooking detection sensor
8 Nozzle
9 Left cover of heating surface
10 Right cover of heating surface
11 Heating surfaces
12 Coffee pots
13 Measuring spoon
14 Left 1cup coffee option
15 Left 2cups coffee option
14+15 Left 3cups coffee option
(touching at the same time)
16 Cup size controller
17 Small cup indicator
18 Medium cup indicator
19 Large cup indicator
20 Water (level) indicator
21 Right 1cup coffee option
22 Right 2cups coffee option
21+22 Right 3cups coffee option
(touching at the same time)

Before first use

Before using your appliance for the first
time, wash all accessories in warm water
with a mild detergent. Please do not use
cleaning tools that may cause scratches.
During first use it is recommended to wash
coffee pots, water tank and spoon hand
wash is recommended. Afterwards, the
washed accessories should be rinsed in
clean water.
Fill water tank up to MAX and wait 10 min.
For the first usage touch 3cups cooking
option on both sides and wait until the end
boiling. Pour boiled water. Place the empty
coffee pots. Repeat it three times.
Preparing the appliance for
operation
In order to prepare your appliance for
operation, follow the instructions below.
■ Connect the appliance to a suitable
power source (data on the nameplate).
(Pic. 1)
■ Press the ON/OFF switch (1) and wait
a few seconds until the appliance is
ready to operate. Icons on the display
will turn on. (Pic. 2)
■ Take out the water tank (3) from the
appliance or leave it in the appliance
and pour with water. (Pic. 3-4)
■ Open the lid (5) and fill the water tank
(3) with appropriate amount of fresh,
cold water between min and max levels.
(Pic. 5)
Info: You can check the water level by
looking on the tank (3) (min max level).
Info: When the water level is above min.
level, water indicator
Info: When the water level is under min.
level the appliance will not operate and will
not brew coffee, water indicator
lights up blinking red. In this case, you must
add water to the water tank (3).
Caution: Max level should not be passed
when water is filled. Exceeding the max
level will cause water leakage under the
device.
Caution: While pouring water directly into
the water tank (3) mounted on the device
(without removing the water tank) be careful
not to spill water on the appliance.
■ Close the lid (5) and place the filled water
tank (3) on the appliance. After placing
the water tank correctly please push the
tank down to be sure it fitted properly.
(Pic. 6)
en
(20) lights up blue.
(20)
19