Haier Cube 83 5 Series User Manual page 9

GB
WARNING!
Do not touch the inside surface of the freezer storage compartment
►
when in operation, especially with wet hands, as your hands may
freeze onto the surface.
Unplug the appliance in the event of a power interruption or before
►
cleaning. Allow at least 7 minutes before restarting the appliance, as
frequent starting may damage the compressor.
WARNING: Do not use electrical appliances inside the food storage
►
compartments of the appliance, unless they are of the type
recommended by the manufacturer.
Maintenance / cleaning
Make sure children are supervised if they carry out cleaning and
►
maintenance.
Disconnect the appliance from the electrical supply before under-
►
taking any routine maintenance. Allow at least 5 minutes before
restarting the appliance, as frequent starting may damage the
compressor.
Hold the plug, not the cable, when unplugging the appliance.
►
Do not clean the appliance with hard brushes, wire brushes, detergent
►
powder, petrol, amyl acetate, acetone and similar organic solutions,
acid or alkaline solutions. Please clean with special refrigerator /freezer
detergent to avoid damage. Eventually use warm water and baking
soda solution - about a tablespoon of baking soda to a litre/quart of
water. Rinse thoroughly with water and wipe dry. Do not use cleaning
powders or other abrasive cleaners. Do not wash removable parts in
a dishwasher.
Do not scrape off frost and ice with sharp objects. Do not use sprays,
►
electric heaters like heater, hair dryer, steam cleaners or other
sources of heat in order to avoid damage to the plastic parts.
WARNING: Do not use mechanical devices or other means to
►
accelerate the defrosting process, other than those recommended
by the manufacturer.
If the supply cord is damaged, it must be replaced by the manufacturer,
►
its service agent or similarly qualified persons in order to avoid a hazard.
Do not try to repair, disassemble or modify the appliance by yourself.
►
In case of repair please contact our customer service.
If the illuminating lamps are damaged, it must be replaced by the
►
manufacturer, its service agent or similarly qualified persons in order
to avoid a hazard.
Safety information
7