Husqvarna BMP 335 Operator's Manual page 16

2. Disengage the drive system.
3. Push down on the handles and the foot support to tilt
the product.
4. Lower the product carefully. The front is very heavy.
16
5. Install the steering lock again.
To clean the product
• Always clean all the equipment after use. Use a
vacuum cleaner.
• Do not use a high-pressure washer to clean the
product.
• Keep the air openings clean and clear to make
sure that the product always has sufficiently cool
temperature.
• Clean the tool drum after operation on moist
surfaces.
To lubricate the bearing
CAUTION:
grease. Refer to
on page 20 . Incorrect type of grease can
cause damage to the bearing.
Use the correct type of
Technical data BMP 335
1838 - 003 - 09.02.2023