Husqvarna BMP 335 Operator's Manual page 11

7. Install the support plate.
8. Do a check of the drive belt tension. Refer to
check of the drive belt tension on page 17 .
To adjust the height of the front wheels
The standard position is (B). Position (A) is used for
operation at maximum depth. Position (C) is used for
operation at minimum depth.
1838 - 003 - 09.02.2023
To do a
A
B
C
1. Loosen the bolts (D) on each side of the front wheel
bar.
D
2. Turn the nut (E) to set the applicable height.
3. Tighten the bolts (D) on each side of the front wheel
bar.
To connect a dust extractor
WARNING:
extractor if the dust extractor hose is
damaged. The risk increases that you
breathe in dust that is dangerous to your
health. Use approved respiratory protection.
D
E
Do not use the dust
A
B
C
11