Panasonic TY-TP42P6S Operating Instructions Manual page 9

Attachment of the touch panel to the plasma display
3
Attach mounting bracket [B]
Tentatively fasten a fixing screw in the left and right speaker mounting screw holes on the rear of the touch panel
and plasma display to attach the mounting bracket [B].
For the 42", you must attach mounting brackets to both sides, and for the 50" you must attach a mounting bracket
to only the right side (looking from the back).
For TY-TP42P6-S Only
4
Lower the tentatively fastened mounting bracket.
Loosen the tentatively fastened bracket mounting screws,
and lower the mounting bracket.
5
Fasten mounting brackets. [A]
Fasten mounting brackets [A] to the display.
TY-TP42P6-S: 4 points in total
TY-TP50P6-S: 5 points in total
TY-TP50P6-S Only
7
Fasten mounting brackets. [B]
Secure the mounting bracket [B] by using a Phillips head
screwdriver to tighten the tentatively fastened screw.
Attach mounting bracket [B]
6
Screw [B]
Fasten the touch panel.
Fasten the touch panel to the display.
After hand tightening the bracket mounting screws, tighten
them further using a flathead screwdriver. Fasten so there
is no large gap between the touch panel and the display
front surface.
Be careful not to overtighten the mounting bracket screws
as this will cause warping.
Mounting bracket [B]
For TY-TP42P6-S/TY-TP50P6-S
9