Tower Setup - Powerware 9125 User Manual

NOTE The PDM must be installed above the UPS as shown in Figure 2.
4. Slide the PDM into the rack.
5. For plug-receptacle models, continue to "Low-Voltage PDM

Tower Setup

The PDM must be stabilized with pedestals and/or joining brackets. The
tower setup varies depending on the total number of cabinets:
1.
2. Place the PDM cabinet horizontally so that the left end of the
Powerware 9125 (2500–3000 VA) PowerPass
®
Installation" on page 18 or "High-Voltage PDM Installation" on
page 19. For hardwired models, continue to "PDM Hardwired
Installation" on page 23.
PDM
UPS
Figure 2. Rack-Mount UPS with PDM
the pedestals and the joining brackets
For one UPS and one PDM,
must be installed. Skip to Step 2.
skip to Step 5 to install the joining
For three or more cabinets,
brackets.
unit is accessible (see Figure 3).
Figure 3. Installing PDM Pedestals with Two Cabinets
Distribution Module User's Guide
®
:
164201392 Rev B www.powerware.com
Installation
15